Skip to main content

How to Get a Comfortable Wearing Experience

This chapter helps you learn how to wear and adjust the glasses for the best wearing comfort and display experience.

1. Wear the Glasses and Make Sure the Image Is Clear​

  1. Connect the glasses to a compatible device that supports DP video output, and make sure the image is displayed properly.

  2. After putting on the glasses, check the following:

  • The image is centered in your field of view
  • The full display area is visible
  • The image is not noticeably cropped or shifted
  1. If the image position or clarity is not ideal, follow the steps below to adjust the fit.

2. Adjust the Wearing Position​

If the image is not centered, or appears too high or too low, try adjusting the temples and replacing the nose pads.

Adjust the Temples​

The temples support 3 levels of vertical adjustment. You can move the temples up or down to find a comfortable wearing angle and see the full image clearly.

Recommendation

When wearing the glasses for the first time, we recommend starting with the middle position (0°), then fine-tuning the angle based on the display effect and your personal comfort.

Replace or Adjust the Nose Pads​

The glasses come with 3 sizes of nose pads (S/M/L), with size M installed by default. Choose the appropriate size based on your nose bridge height. Choosing the right nose pads helps improve image clarity and overall wearing comfort.

Recommendation

If the image appears too high or too low, try changing the nose pad size. Size S nose pads position the glasses relatively higher, while size L nose pads position the glasses relatively lower.

Nose Pad SizeSuitable For
S (Small)Higher nose bridge
M (Medium)Medium nose bridge height (default)
L (Large)Lower nose bridge

Install Prescription Lenses (If Needed)​

After installation, make sure the lenses are securely fixed and check the image alignment again.

Note

If you are not sure how to install the prescription lenses, we recommend contacting e-commerce customer service or visiting a professional optical store for assistance.

3. Test the Button Functions​

Before regular use, make sure all buttons work properly.

  • Test the 「X」 button: Click the 「X」 button to turn 「Stabilization」 on/off, and double-click the 「X」 button to open the OSD menu.
  • Test the 「+/-」 buttons: Click the 「+/-」 buttons to adjust screen brightness, and press and hold to adjust brightness.

4. Start Using​

After completing the adjustments above:

  • Make sure the image is stable and clear
  • Make sure the glasses fit comfortably and securely

Note​

The left temple area of the glasses may become slightly warm during use. This is normal. This area does not come into direct contact with the skin and is safe to use.